Monday, March 1, 2010

Oar Prototype #1

I lost power and internet for a bit during the big blow the other day, and never posted pictures of the oar. The following day I decided to shape the oar up. Using my plane, block plane, random obit sander, chisel, and wishing that I had a spokeshave, I went to work. In about three hours I got the below product. As you may notice, there is a kink where the blade meets the loom. Also, I screwed up the shaping a bit.



I mean, for a first oar done in three hours, not bad.

The blade is kinked to the loom most likely because each measurement station was taken off the edge of the board as opposed to off a theoretically straight line connecting the two ends. So if there was any deviation in the way the board has been originally cut (most likely) then the oar would reflect that in waviness-- and that's what happened. My next oar measurements will be based off a straight line down the board.

Second, I started shaping the oar without squaring it first. This would have been an easy endeavor, however I was excited to get started and planed the thing into an oval. If I had made sure all 4 sides were square, it would have been a circle.

The grip is also oval, I think it might be rough on the hands. I should not have cut it out in the blanks, and shaped it at a block, that way I could have made it a circle with a 1 1/4" diameter as opposed to the 1" it is now (a little small for me).

In the end, an easy plan, a nice looking oar, it's light, and with the pine was easy to shape.

Prototype #2 is in the works. This too, will probably be a scrapper because I already cut out the grip and then realized the advantages of cutting it out when the blank was glued up.

No comments:

Post a Comment